| Product Specifications: |
| SHIELD PRODUCTS |
Application for Water Slides
Smooth Finish |
| |
|
Note:
Fiberglass and gel coat are very porous. They hold silicones and various other products detrimental to coating.
Please Follow Instructions:
Spray slide with Shield Super Cleaner SKU 50800. Wait 10-15 minutes. (Do not allow to dry!). Pressure wash and rinse slide. This will remove most silicones. Allow to dry!
Recommended: For smooth surface apply one coat SKU
20900 Epoxy primer/sealer. Sand primer to application. This will address any moisture
problems you may have and finish off the surface preparing it
for the Fluoropolymer top coat will prevent silicones from
coming up..
Epoxy first coat: Add color to Epoxy coat and
apply directly to slide. Apply enough to hide. Go directly to second coat. |
| |
First Coat:
When not using Epoxy.
Apply very light mist coat with clear SKU 20059. Apply second coat when tack free. |
| |
Second Coat:
If not using Epoxy.
Apply color coat (SKU 20059),
2 mil wet, will be tack free in 30 to 60 minutes. (Be sure to use Catalyst, 4 oz per gallon). |
| |
Third Coat:
Apply clear fluoropolymer (SKU 20059- 2 mils wet
when second coat is tack free. (Be sure to use Catalyst, 4 oz per gallon). |
|
| |
|
Colors: Available in all coatings. Recommend colors be
put in Epoxy. Recommend 844 Colorants. We stock all
colors..
Total Application Requires Three Coats .
Note: When not using Epoxy base coat.
Apply mist coat of Fluoropolymer. Allow to dry, Takes minutes.. Apply Second Fluoropolymer color coat when tack free
Approximately 45 minutes,. Apply third coat of clear Fluoropolymer when second coat is tack free. Cure time
5- 7 days, subject to heat and humidity. Dry enough to walk on in 6
-10 hours. Traffic 24 hours. Total cure 5- 7 days.
Cleaning Equipment:
Clean Fluoropolymer applying equipment with MEK or some type
of Ketone solvent.
|
|
SHIELD PRODUCTS, JACKSONVILLE, FL |
|
|
"WHEN YOU WANT THE VERY BEST" |
